|
GDC - Grout
Haze Remover
-
Use to remove excess
grout haze from tile & grout, seven days after installation of tile. Sold as
concentrate in 8 ounce bottle, just add haze remover to two gallons
of water and let stand for about 5 minutes so product can dwell, don
not allow to dry. Apply to tiled area scrub floor with a stiff nylon
brush. Then rinse floor with
water and mop up excess. Use to remove Grout Haze Residual and
also to remove organic dirt from grout and to slightly etch the
grout and open the grout pours.
-
Just add our GDC
Liquid Grout Haze Remover to your two gallon bucket of water. This
product is sold in an 8 ounce bottle, but when mixed with your
cleaning water this solution covers up to 200 square feet
-
Do not use on Natural
Stone Tiles, such as Marble, Tumbled or Polished Marble, Granite,
Honed or Polished, Terra cotta, and other natural surfaces.
-
Do not let this
acidic product come into contact with metal surfaces such as
Stainless Steel , Brass, Copper, Bronze, Zinc, such as Sinks,
Fixtures, Tubs etc.
-
Do not discard waste
water in sink if it is Stainless Steel , Brass, Copper, Bronze,
Zinc, such as Sinks, Fixtures, Tubs etc.
CAUTION
-
Keep out of reach of
children
-
Do not take
internally
-
Avoid contact with
eyes
-
Gloves and eye
protection should be worn during application
-
IF INGESTED: Drink 1
to 2 glasses of water. If symptoms persist, seek medical attention
-
EYE AND SKIN CONTACT:
Flush thoroughly with water. If irritation persists, seek medical
attention
-
Always do a test area
first, wait 1 hour for results
-
Close container after
each use
-
For best results, do
not store in direct sunlight or in temperatures above 110° F (43°
C)
-
Use in temperatures
between 50 and 80° F (10 and 27° C)
|
